Forgot to make a post about the Rev B of Icarus (I did this a few months ago). This is primarily about reducing the size of the PCB and fixing...
In my last post I showed some configurable LED panels I designed using OpenSCAD. For the LEDs I used a neopixel ring I picked up a while back from...
Definitely not the first 3D printable LED panel out there. But, typically designs on thingiverse are nanoleaf clones. So the design tends to be triangular. What if you want a...
TLDR My issue was loose eccentric nuts on the Y axis v-slot wheels. Ensure these are tightened, but also ensure the nuts on the x-carriage are also tight. If these...
To go along with the Icarus Controller, I’ve designed a power distribution board that allows it to be connected to a battery. Scope I’d like this board to power...